AGN Subscribe - Large Banner

What the Army’s ADS-B findings mean for airlines

Findings from the US Army's January 2025 collision investigation highlight why ADS-B In remains a critical tool for improving situational awareness and flight safety.

Acron
Photo: Acron

This article is sponsored by Acron Aviation.

The Army has now completed its investigation into a January 2025 incident near Washington Reagan National Airport. Its findings echo long-standing NTSB recommendations, which have called for ADS-B In since 2006.

Many commercial aircraft still fly without ADS-B In. Without it, crews cannot display nearby traffic broadcasting in the area, so the findings matter well beyond one accident.

“Out” keeps you visible, “In” keeps your crew informed

ADS-B Out broadcasts an aircraft’s position, altitude, speed and identity, so others can see it. ADS-B In gives pilots a GPS-precise picture of surrounding ADS-B Out traffic up to 180 nautical miles, updated every second. ADS-B In systems can support Interval Management for more efficient en-route spacing and CAVS for precise visual separation in reduced visibility, delivering gains in capacity, fuel efficiency and safety simultaneously.

Put simply, “Out” lets others find you and “In” lets your crew find them. The findings show the gap on both sides. An aircraft that does not transmit correctly is hard to see, and a crew without ADS-B In cannot effectively display the traffic around it.

The wider case for pairing TCAS with ADS-B In is that the two systems do different jobs. TCAS issues collision alerts when aircraft get too close. ADS-B In shows crews the traffic around them before that point.

What the Army investigation found

The UH-60L’s transponder had an incorrect Source Reference Code configuration. That setting stopped it from transmitting ADS-B Out properly, so other aircraft could not rely on the helicopter’s broadcast position.

The 12th Aviation Battalion also ran a mixed fleet of older UH-60L and newer UH-60M helicopters for about seven years. Running two variants made equipment, maintenance and procedures more complicated.

The Army has since completed a mandatory SRC verification. It has also recommended that all Army Aviation Brigade and 12th Aviation Battalion helicopters carry ADS-B Out and ADS-B In capability, TCAS II and correct transponder configuration.

What this means for airlines

Airlines frequently operate in the same congested airspace as the Army, so they face the same questions the Army has had to answer. Operators should know which aircraft carry ADS-B In. They should check that each transponder is set up correctly. Where a fleet includes more than one airframe, they should record the settings and check them consistently.

The lesson applies directly to commercial aviation, where many aircraft still lack ADS-B In. Any operator with mixed equipment, legacy systems and busy approaches should act on it. Fleets change through deliveries, retrofits and variant mixes, so this needs to be ongoing.

Why the configuration check matters

Equipment only helps when it is set up correctly and checked. TCAS II is the system that issues Resolution Advisories, which tell crews to climb or descend to avoid a collision. Without the right equipment, crews rely more heavily on visual cues to avoid other traffic.

Confirming that equipment works as intended after every relevant maintenance event should be part of standard operating procedures.

Operators should take four actions:

  • Confirm the source reference code on each transponder against the installation specification
  • Verify ADS-B Out after each relevant maintenance event
  • Keep a current record of which aircraft carry ADS-B In
  • Record settings for each variant in a mixed fleet

Where SafeRoute+ fits

SafeRoute+ is an ADS-B In retrofit solution from ACSS, part of Acron Aviation. It is a software upgrade to existing TCAS 3000SP or T3CAS systems for commercial aircraft. SafeRoute+ creates an environment of shared traffic situational awareness between pilots and air traffic controllers, providing a 180 nautical mile traffic picture.

It uses the existing displays to provide basic ADS-B In information; and the new ADS-B Guidance Display (AGD) from ACSS for advanced applications. These are AIRB, CAVS, Interval Management and In-Trail Procedures.

The policy debate

US lawmakers have recognized these pressures and are proposing regulation that would mandate ADS-B In technology in the flight deck. This mandated display of ADS-B traffic information would provide pilots with better situational awareness of surrounding traffic, allowing for a more proactive role in separation management.

Mandates and voluntary upgrades can run side by side. Teams that wait for a final rule may have less time to plan the work. Airlines do not need to wait for the outcome to review their own equipment and records.

Next steps for airline safety

The full investigation report is worth reading for anyone responsible for airline safety. Airlines should confirm which aircraft carry ADS-B In, and check when each transponder’s settings were last verified against the approved configuration.

For the full picture on where airlines stand, read Acron’s 2026 ADS-B In readiness report. It draws on research with 100 US airline executives and looks at adoption, understanding and the barriers that hold airlines back.

Sign up for our newsletter and get our latest content in your inbox.

More from